Charged Glock Slide Cover Plate by FFFTech/FFFTechnology
A cover plate for Glocks that extend past the rear of the slide; has protrusions
on both sides to aid in racking the slide. Used in case one has weak hand strength,
is reloading under stress, or the weapon is slippery due to precipitation and the like.
Design is inspired by the H&K VP9's "Charging Supports".
Designed for Glock Gens 3 & 4.
Not compatible with Gen 5 Glock models, as well as single stack model.
(This device DOES NOT change the firing mechanism of pistol. The weapon will still
ONLY function as any other semiautomatic firearm.)
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 15%
Support material only needed in the channel of the cover plate that locks
into the rear of the slide.
I printed the supports with an X/Y offset of .4mm, any less and the support
material seemed to fuse to the side of the model for me.
Print in PLA+ or stronger material (Not Standard PLA)