an open beta for a non-sbr Urutu rear assembly.
Latch takes approx 1in by .25in springs and a m3 bolt
Playing with it on the bench its apparent that the latch needs to be a close fit to feel solid, as such I have them modeled at the nominal dimensions so if your printer runs large you will need to sand or scale the latch slightly.
I have this as a beta file as I haven't had a chance to see how the m3 pivot will hold up longer term, might have to switch it out for an m5 or something
File | Extension |
---|---|
urutau storage stock.rar | rar |
Version: 1.0.0 latest
initial upload
an open beta for a non-sbr Urutu rear assembly.
Latch takes approx 1in by .25in springs and a m3 bolt
Playing with it on the bench its apparent that the latch needs to be a close fit to feel solid, as such I have them modeled at the nominal dimensions so if your printer runs large you will need to sand or scale the latch slightly.
I have this as a beta file as I haven't had a chance to see how the m3 pivot will hold up longer term, might have to switch it out for an m5 or something
660
173
Aug 23, 2024
United States
English
No license
File | Extension |
---|---|
urutau storage stock.rar | rar |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.