This is the KittyKan by gerald.katz
The KittyKan is a fully 3dprinted flash can with threads to fit most barrels. This project started with my need to populate a barrel for a mostly printed AR build. What I found was that while you can find 1:1 replicas of muzzle devices none were printable without chasing threads. Without the proper tap I decided to go on to make printable threads without the need of post processing. The end project was an entire gambit of printable threads most barrels attached to a clone of the Flaming Pig Flash can. The threading profiles will be posted as a guide shortly after this release. This flash can has been tested to hold up to 556 without issue other than heat soak. Just like a Biden's Bain if you heat it up too much it will start to melt. It may fit barrels with larger chamberings, but hasn't been tested for operation with those. There are 23 versions of the file in the pacakge. As the thread sizes increases there were three iterations of larger and reinforced Kans. i.e. 3/4x10 is bigger than 1/2x28 but smaller than m26x1.5
File | Extension |
---|---|
KittyKan.zip | zip |
Version: 1.0.0 latest
initial upload
This is the KittyKan by gerald.katz
The KittyKan is a fully 3dprinted flash can with threads to fit most barrels. This project started with my need to populate a barrel for a mostly printed AR build. What I found was that while you can find 1:1 replicas of muzzle devices none were printable without chasing threads. Without the proper tap I decided to go on to make printable threads without the need of post processing. The end project was an entire gambit of printable threads most barrels attached to a clone of the Flaming Pig Flash can. The threading profiles will be posted as a guide shortly after this release. This flash can has been tested to hold up to 556 without issue other than heat soak. Just like a Biden's Bain if you heat it up too much it will start to melt. It may fit barrels with larger chamberings, but hasn't been tested for operation with those. There are 23 versions of the file in the pacakge. As the thread sizes increases there were three iterations of larger and reinforced Kans. i.e. 3/4x10 is bigger than 1/2x28 but smaller than m26x1.5
1.6K
114
Jul 15, 2023
3D Printer
United States
English
No license
File | Extension |
---|---|
KittyKan.zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.