10/22 2/10 Blast Vent Brake: FFFTech/FFFTechnology
Similar to the 3-9 Blast Break, but with gas redirection vents on the 2 and 10 o clock postions of the device.
Printer Used: Ender 3 V2
Filament Used: PLA+
First Layer Print Height: .18mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 6+
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 20%
1x M3x16 Set Screw
SAFETY NOTE: Due to this design coming into contact with hot metal and gasses, it's HIGHLY recommended to print the design, and use Lost PLA Casting in metal for the finished object. The printed version CAN be used, but should not be expected to retain structural rigidity for more than a few dozen rounds fired.