3FTech Glock Magazine Baseplate (Dot Matrix Update): FFFTech/FFFTechnology
A replacement 3D printed baseplate for double stack Glock magazines. Updated with a
4x4 dot matrix to allow for marking mags for identification.
Compatible with Gen 3-4 Glock magazines.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 204C
Bed: 54C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5
Infill: 36%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 25%
Support X/Y Offset: .34mm
(Block supports for the dot matrix in Cura)
File | Extension |
---|---|
3FTech GMag Baseplates (Dot Matrix Update).zip | zip |
Version: 1.0.0 latest
3FTech Glock Magazine Baseplate (Dot Matrix Update): FFFTech/FFFTechnology
A replacement 3D printed baseplate for double stack Glock magazines. Updated with a
4x4 dot matrix to allow for marking mags for identification.
Compatible with Gen 3-4 Glock magazines.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 204C
Bed: 54C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5
Infill: 36%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 25%
Support X/Y Offset: .34mm
(Block supports for the dot matrix in Cura)
4.2K
Aug 22, 2023
United States
English
QmdCRKLgUEQchcmzNsq4iwMEeGDqwHiK8LzXD3A2u9Gcxx
File | Extension |
---|---|
3FTech GMag Baseplates (Dot Matrix Update).zip | zip |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.